|
Post by ke4unr on Jul 3, 2006 7:38:44 GMT -7
I started using my effects loop on my Maz JR NR 210 recently. I'm getting noise. Not severe, but enough to be annoying. When not using the loop, the amp is dead quiet.
I'm running only two pedals, Boss DD-3 and Digitech DigiDelay both powered from a DMC Pedal Power. The noise is there even if the pedals are not activated and doesn't change when they are.
My patch cables are top quality and I've used the same setup/gear through my Classic 30 for years with no problems.
Any ideas?
Thanks, Ray K.
|
|
|
Post by kruzty on Jul 4, 2006 5:31:14 GMT -7
What happens if you put a cable directly from the send to the return?
|
|
|
Post by ke4unr on Jul 6, 2006 19:37:56 GMT -7
What happens if you put a cable directly from the send to the return? Dead quiet, kruzty! Duh, it couldn't have been one of my special homebrewed cables gone bad... Well, my cable tester doesn't call it bad, but it has certainly gone microphonic. I have an identically built cable (Canare cable, G&H right angle, Neutrik straight ends) that works fine on my pedalboard. Oh well... Thanks for helping brighten my light bulb, and my day! +1 for you! Ray K.
|
|