|
Post by rodeoclown on Mar 7, 2006 22:27:30 GMT -7
What's the best way to ditch the big wah rubber feet and attach it with velcro to the board?
|
|
|
Post by Lefty on Mar 8, 2006 6:56:03 GMT -7
www.stompin-ground.com/products/sgwahplate.htmCheck this out. I was debating on going this route, but I have some cables going under my wah so the plate would kinda screw things up for me. I put velcro squares on the feet of my wah, and so far so good. Granted, I haven't moved it around a lot recently so the jury is still out. I may have to make a custom plate with room in the center for cables.
|
|
|
Post by bluzsteel on Mar 8, 2006 7:11:31 GMT -7
I take off the rubber feet and put a washer between the screw and the plate of the Wa, it allows the velcro to stick out real solid
|
|
|
Post by iggs on Mar 8, 2006 7:21:57 GMT -7
I kept the rubber feet but built a little platform out of 1/4 inch plywood and routed holes for the feet, then I spray painted it black and dressed the whole thing in Velcro ... ended up looking quite pro and the Wah is rock-solid.
|
|
|
Post by RC on Mar 8, 2006 12:46:05 GMT -7
I just took off the rubber feet and replaced them with two piece's of Aluminum flat bar stock 3/16"x1"x3 1/4". It's sold by the foot at out local hardware store. You just cut to length to fit one over the top two holes and one over the bottom two. Then drill a 1/8" hole, countersink, and screw them on with the original screws. I then covered the two plates with Velcro to attach to my pedal board. This is actually harder to describe than make.
|
|