|
Post by paulreeddrz on Dec 30, 2006 23:51:53 GMT -7
I just bought a road case for my es head , it fits in it perfect but the power cord gets kinda bent right where it comes out of the amp due to the foam being an exact fit of the head, think it will eventually wiggle loose or anything?
|
|
|
Post by DRZ on Dec 31, 2006 5:21:51 GMT -7
Here's a little tip. I wish I had a pic of one I did this way, as a pic is worth a 1000 words.
Get a 3/8" cable tie down, like one used on inside of a combo amp to tie back cables. If you stand it up it looks like the letter P the cable goes into the opening and the tabs have a hole to mount a screw.
Run the power cord threw the tie down ( strain relief ) bend cord 90 degrees at attach under the fuses to the lower lip of the cab box.
This will keep the cable from flexing, stretching , and being pulled from the chassis connection.
I know I have done this to amps in the past if anyone has a pic please post it.
DR.Z
|
|