|
Post by rickyp on Dec 17, 2018 23:01:05 GMT -7
I’ve got a Z-Plus 1x12 combo, thought about grabbing a 1x12 cab to go with it. Anyone here ran a combo with a cab for gigging?
|
|
|
Post by John on Dec 18, 2018 3:42:19 GMT -7
Yes...but you'll need a cable splitter out the back of the amp.
Forum member Benttop often posts a pic of his old combo with extra cabinet setup.
|
|
|
Post by daddyelmis (Greg) on Dec 18, 2018 5:15:35 GMT -7
I’m running a Z 2x10 under my ZPlus. Using one of Todd’s Y cables.
|
|
|
Post by buckeye on Dec 18, 2018 6:39:07 GMT -7
I’m running a Z 2x10 under my ZPlus. Using one of Todd’s Y cables. Are you using the speaker in the Plus as well? If so what impedance is the 2X10 cab and which speaker out are you using?
|
|
|
Post by daddyelmis (Greg) on Dec 18, 2018 9:31:29 GMT -7
Each speaker is 8 ohms (the internal 8ohm speaker and the 2x10 running 2-16ohm Z speakers wired in parallel for a total of 8 ohms). So the amp is seeing 2-8 ohm loads in parallel for a 4ohm total load. So I plug the Y cable into the 4 ohm output on the amp and connect the internal speaker and 2x10 cab to each “leg” of the Y cable. Easy Peazy.
Todd makes a particular Y cable with a shorter female leg to plug into the internal speaker’s male lead (the one that normally plugs into the amp) and a longer male leg to reach the cab and plug into the female jack plate there.
|
|