|
Post by cheycaster on Feb 25, 2008 19:42:23 GMT -7
sounds like a question for the good Doc Z himself on that one............good luck!
|
|
|
Post by hdahs143 on Feb 25, 2008 21:43:59 GMT -7
Carefully inspect the 4 wires going to rectifier tube socket. 2 of them (ususally yellow) provide 5 volts AC from the power tranny to heat the filament in the tube. If either wire is unconnected, or has a bad solder joint, the tube will not light up, and consequently not work.
Use a chopstick to poke around if you have one.
Good luck
Harold
|
|