|
Post by hfasteve on Jan 3, 2020 10:50:05 GMT -7
I have a maz 8 head and I want to put it in a studio combo that I built. This would make all the controls upside down. I’ve read somewhere in this forum about getting a new faceplate that would be right side up. However I’m a little confused , because the pots and switches would still be the wrong way, right?
|
|
|
Post by premiumplus (Dave) on Jan 3, 2020 11:06:08 GMT -7
I'm pretty sure that the Maz series faceplates have the reverse lettering on the other side of the plate. Flip it over and you're good to go. Might be a good idea to verify with Don at Z repair first, or loosen up the input jacks and first few pots to have a peek.
BTW, welcome to the forum. There's a group of great folks here.
|
|
|
Post by hfasteve on Jan 3, 2020 11:26:33 GMT -7
Cool! Thank you! I will check it out. This place is great.
|
|
|
Post by Jaguarguy (Mike) on Jan 3, 2020 14:00:19 GMT -7
Welcome to the forum! There is a lot of great people and information here. Best Forum on the interwebs!
|
|