|
Post by tailwheel on Dec 11, 2018 11:54:27 GMT -7
I purchased a new Cure a couple of weeks ago and have 5-10 hours on it. I powered up the AMP last night and it immediately started producing a very loud hum/squeal that only increased with volume. The noise is such that the AMP isn't usable. The cause of the problem couldn't be isolated to any particular input be it a pedal/guitar.etc. Prior to this, the AMP was very quite, and exhibited no excessive noise from my input chain. I've purchased a replacement set of new tubes and intend to perform a tube swap when they are delivered. Hopefully it just a bad tube.
Any other ideas?
Thanks
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 11, 2018 11:57:44 GMT -7
|
|
|
Post by pcns on Dec 11, 2018 11:58:31 GMT -7
It will end up being a bad tube. When you get the new set be sure to replace them one at a time so you can isolate the bad tube. No need to replace them all.
|
|
|
Post by doctorice on Dec 11, 2018 12:24:37 GMT -7
If you bought it new from a dealer, anything other than a tube should be covered under warranty.
|
|
|
Post by mudman on Dec 12, 2018 6:29:43 GMT -7
If you bought it new from a dealer, anything other than a tube should be covered under warranty. Usually tubes too even the first few months right?
|
|
|
Post by doctorice on Dec 15, 2018 7:08:51 GMT -7
If you bought it new from a dealer, anything other than a tube should be covered under warranty. Usually tubes too even the first few months right? Yes, Dr Z website says 90 days on tubes.
|
|