|
Post by Roland on Jul 11, 2017 23:54:34 GMT -7
Hi.
Does the KT45 have a bias control?
I am planning on getting a TAD/ Weber Bias kit and do it myself.
Just wanted to check if anyone knows, before I go ahead and open the amp up.
Thanks!
|
|
|
Post by Jaguarguy (Mike) on Jul 12, 2017 7:18:32 GMT -7
|
|
|
Post by Roland on Jul 13, 2017 4:59:36 GMT -7
Hi. I was more wondering if there was a bias adjustment control inside?
|
|
|
Post by doctorice on Jul 13, 2017 5:27:56 GMT -7
Hi. I was more wondering if there was a bias adjustment control inside? I don't have a KT-45, but I have a 6545, which is a KT-45 and SRZ-65 on one chassis. The bias adjustment on this amp, and the other Zs I've owned that require biasing, is located on the amp chassis. It's a small variable resistor that you adjust with a screwdriver. It can only be accessed by removing the chassis from the amp case. Obviously you have to have the amp powered up to do the biasing, so be sure to observe safety protocols.
|
|
|
Post by Roland on Jul 13, 2017 6:30:42 GMT -7
Thank you very much. I don't have some experience in electronics so I will make sure I am safe. Thank you once again!
|
|