|
Post by simpleton on Dec 9, 2016 18:28:40 GMT -7
With the Therapy venting on top I have assumed I shouldn't put the ZVerb on top of my Therapy....but I want to have it on top sooooo do you think the heat is going to be terrible for the Verb? I do but am hoping I am wrong.
I get issues with it on the floor from the drums and it was feeding back...also it splashes if right on top the cab first with the Therapy above it.
just a newbie with out board reverb learning how to run it live. I have been home bound mostly but want to get out again.
|
|
|
Post by nmz on Dec 9, 2016 18:33:33 GMT -7
**** Dale would hoist his with a rope. Not sure but I bet it would be ok.
Wow it won't let me post **** so how about Richard.
|
|
|
Post by dardeau on Dec 9, 2016 19:43:15 GMT -7
**** Clark, counting down.
|
|
|
Post by purpletele on Dec 9, 2016 19:54:56 GMT -7
With the Therapy venting on top I have assumed I shouldn't put the ZVerb on top of my Therapy....but I want to have it on top sooooo do you think the heat is going to be terrible for the Verb? I do but am hoping I am wrong. I get issues with it on the floor from the drums and it was feeding back...also it splashes if right on top the cab first with the Therapy above it. just a newbie with out board reverb learning how to run it live. I have been home bound mostly but want to get out again. The Therapy does tend to get a bit warm, I use a couple of pieces of hardwood that I cut and put some felt feet on them, and I use it to lift and provide sufficient air space for the heat to dissipate from the Therapy when I am using my Power Station on top.
|
|
|
Post by simpleton on Dec 10, 2016 10:31:37 GMT -7
Thanks for the replies...do you think the heat from the amp will make the tolex warp on the Verb?
|
|
|
Post by purpletele on Dec 10, 2016 10:51:40 GMT -7
Thanks for the replies...do you think the heat from the amp will make the tolex warp on the Verb? Simpleton, I think that if heat caused a problem with the tolex then the top and back of the Therapy would be unraveling at the seams. However, it is something to be concerned. I didn't give you all the facts on my high tech stacking sticks. I use two felt feet on each corner to add a total of 1 1/2 inches off the top of the Therapy.
|
|
|
Post by simpleton on Dec 10, 2016 14:21:56 GMT -7
Thanks for the replies...do you think the heat from the amp will make the tolex warp on the Verb? Simpleton, I think that if heat caused a problem with the tolex then the top and back of the Therapy would be unraveling at the seams. However, it is something to be concerned. I didn't give you all the facts on my high tech stacking sticks. I use two felt feet on each corner to add a total of 1 1/2 inches off the top of the Therapy. Well I am trying to shrink my set up so I don't want to make a riser.....at this time at least. Good point on the tolex on top of the Therapy....I also figured a floor fan behind would help if needed...but I am trying to shrink the set up gear.
|
|