|
Post by Geoff on Jan 3, 2015 8:42:08 GMT -7
I recently purchased an older model Brake Lite (hard wire type) that has two speaker outputs. Looks to be a mod. I was wondering if anyone has seen this before and if it is OK to use...Looks to be some sort of paralell output for another speaker but who knows....
|
|
|
Post by benttop (Steve) on Jan 3, 2015 11:16:58 GMT -7
Shouldn't be a problem as long as you understand how it is wired. A paralleled jack is going to be identical to one of Todd's Y cable adapters impedance-wise. You do need to understand what amplifier jack to use based on the impedances of the two speakers you plug in to the BL. If both speakers are the same impedance, use the jack that is half that impedance. In other words, if you plug two 8 ohm speakers into the BL, use the 4 ohm jack on the amp.
|
|
|
Post by Geoff on Jan 3, 2015 13:10:38 GMT -7
Thanks, I only plan on plugging in one 8 ohm speaker (112 Combo) so I gues it shouldn't matter as long as I don't plug into two speakers. Two speakers in parallel (half the impedance) would have to be equal impedance, two eight ohm speakers (parallel) = 4 ohms output, two 16 ohm speakers (parallel) = 8 ohms output, etc....
|
|