|
Post by justingiles on Jul 1, 2013 11:17:12 GMT -7
The Z Verb sounds FANTASTIC!!!!! However I'm getting a high pitched squeal when I turn it on sometimes (most times). It comes and goes as I move the unit ever so slightly around and if it doesn't squeal and I run an eq pedal at unity volume it squeals. But below unity volume on the eq pedal it's fine but then the volume is choked.
I don't really know why it's doing this. Any suggestions?
Thank you for any help!!!!!!!!
|
|
|
Post by Jaguarguy (Mike) on Jul 1, 2013 11:26:43 GMT -7
Is it sitting on top of your amp? That can cause problems. Try moving it off the amp. Also, try removing and seating all the tubes. Finally, tighten all the bolts on the holding the chassis in place. Sometimes a loose bolt can cause issues.
If all else fails, send a note to the folks at Dr. Z service - maybe Don can walk you through it over the phone.
|
|
|
Post by justingiles on Jul 1, 2013 12:19:15 GMT -7
Thanks
It has been moved everywhere so placement isn't the problem
I don't know what seating all the tubes means, sorry
I'll check the bolts
|
|
|
Post by heynewguy (Ol’ Bill) on Jul 1, 2013 16:26:06 GMT -7
Make sure the reverb cables are on good and tight.
|
|
|
Post by Jaguarguy (Mike) on Jul 1, 2013 17:17:33 GMT -7
Thanks It has been moved everywhere so placement isn't the problem I don't know what seating all the tubes means, sorry I'll check the bolts Just take the tubes out and put them back in making sure they are snug
|
|
|
Post by justingiles on Jul 2, 2013 7:40:04 GMT -7
Ok I'm on it
Thanks for the help guys!
I'll let you know how I make out
How do I check the reverb cables?
|
|
|
Post by Jaguarguy (Mike) on Jul 2, 2013 7:52:19 GMT -7
Ok I'm on it Thanks for the help guys! I'll let you know how I make out How do I check the reverb cables? Unplug and replug them back in.
|
|
|
Post by justingiles on Jul 3, 2013 18:15:18 GMT -7
Ok so I tried a bunch of stuff and the unit is working fine except for when the mix knob is turned up past 10 o'clock
Is that normal?
Thanks again guys for all of your help!
|
|
|
Post by Jaguarguy (Mike) on Jul 3, 2013 18:32:06 GMT -7
Shouldn't be squealing.
|
|