|
Post by jzguitar on Oct 17, 2005 10:26:58 GMT -7
Hey everyone
I seem to have either stripped or cross-threaded one of the speaker mounting holes in my Mazerati. I was trying my Eminence speakers and they don't seem to line up with the holes as well as the Celestions. I probably forced it a bit too much. Now the screw goes in a little and then stops. Just wondering if anyone had any suggestions. The other three screws go in fine. I may check Home Depot to see if there is something I can re-thread the hole with. Any help would be greatly appreciated! Thanks!
jz
|
|
|
Post by bluzsteel on Oct 17, 2005 11:31:23 GMT -7
that happened to me I used a different screw and it went in, worth a try
|
|
|
Post by Buzz Fretwear (Ignatius) on Oct 17, 2005 11:42:50 GMT -7
John, I think you could rethread the post with a tap/die kit. I've never done it, but I've seen it done (but not to a speaker mount). You'll end up with a smaller diameter thread and you'll need a new nut. A local machine shop might be able to do it for you for a couple of bucks.
|
|