Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jul 27, 2009 9:13:22 GMT -7
My Zverb was fine all last week at home. I get to a gig this past Saturday and every time I plugged it in either in front or in the effects loop I'd have about half the volume as plugging in to my amp with out the zverb. Its only a few months old and I haven't used it that much so I don't know if it would be tubes. Cables seem fine. Does anyone have any ideas where to start trouble shooting this?
|
|
|
Post by douglong on Jul 27, 2009 13:37:29 GMT -7
I would start with a new 6V6 power tube....then try the pre-amp tubes one at a time.
|
|
|
Post by DRZ on Jul 27, 2009 15:41:17 GMT -7
Have you tried it again since the weekend, with differant cables maybe?
Worked fine at home get to a gig and it cuts power in half, maybe a tube needs re-seating , or a bad cable .
Z
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 15, 2009 9:42:25 GMT -7
I've been so busy I never got the chance to get back to this thread about this problem. Last weekend I had no gig so decided to go through my gear and inspect everything. I have had some problems with a footswitch cutting out on my pedal board and various other little issues I haven't had time to address as I've been gigging every weekend. Sprayed some contact cleaner on some trouble spot issues checked and reseated tubes rearranged some things on my pedal board. Last night I played the first of a 2 nighter and my rig sounded better than it has in ages. I had a perma smile on my face the whole night.
|
|