|
Post by thewez on Apr 29, 2018 16:34:32 GMT -7
Hello everybody! How do you replace/exchange a speaker in a Maz 18 Junior? I just want to experiment a little and I'm not a mechanical expert. Thanks
|
|
|
Post by digs57 on Apr 29, 2018 18:29:45 GMT -7
You may want to remove tubes depending how you rate your self (mechanically skilled)...I take the two panels off...face down carpet/alike...start loosening screws...once done see if you can lift a little!...if budges your in...if you have to use effort...I hope you don't have use your foot to hold it (cab) down...one amp speaker wasn't going to move so it stayed...
If success is had...install and carefully align the holes...bright flashlight can help to start your first screw and so on...get them so-so tight at first...then alternate being care full not over do anything...that said...I do like mine snug so it doesn't have to be messed with...with snug up in due time...good luck
|
|
|
Post by John on Apr 30, 2018 3:40:39 GMT -7
^^^^ The only questionable/dangerous areas are:
1) hitting a tube upon removal/installation 2) If the speaker appears stuck to the cabinet and won't lift off easily 3) Be careful to not puncture the new speaker when trying to center it upon installation. 4) Upon installation of the new speaker, don't tighten the screws so much that you bend the speaker frame.
|
|