|
Post by twanghang on Jan 25, 2018 12:45:13 GMT -7
New to Dr Z amps and this forum, but I'm a very happy new owner of a Stang Ray combo. I use a Line 6 Helix for my time-based effects (reverb/delay/modulation), in the effects loop. When I try to configure using the 4 cable method (time based effects in the Stang Ray loop, all others in the front end of the amp), the Tone and Cut controls seem to be inactivated/bypassed. Has anyone had any experience with this issue or know what's going on and how to avoid this? Thanks!
|
|
|
Post by captainron (Ron) on Jan 26, 2018 11:30:24 GMT -7
Hello and welcome! I would send the repair department a note about this for faster response.
repairs@drzamps.com
Congrats on a great amp. Hope you get the problem resolved soon.
Ron.
|
|
|
Post by tehtrav on Jun 23, 2018 9:22:23 GMT -7
New to Dr Z amps and this forum, but I'm a very happy new owner of a Stang Ray combo. I use a Line 6 Helix for my time-based effects (reverb/delay/modulation), in the effects loop. When I try to configure using the 4 cable method (time based effects in the Stang Ray loop, all others in the front end of the amp), the Tone and Cut controls seem to be inactivated/bypassed. Has anyone had any experience with this issue or know what's going on and how to avoid this? Thanks! Kinda sounds like a routing issue. Are you using a Send and Return block in your Helix patch? If you have the Z’s preamp in one of the Helix Fx loops you have to make sure to put it in the path or Helix will just skip it and go straight to the power section.
|
|