|
Post by digs57 on Jan 19, 2018 8:57:37 GMT -7
Seems like this is just happening with new ghia...suhrs are nice and quiet...minimal ground click if at all...prs s2 a little more prevalent.
The tc electronics pedals...what gives...Read dc leak?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 19, 2018 9:18:28 GMT -7
What are you using for power? Try switching up the order of the pedals on the power supply taps.
I had two delays that were both drawing about 300mA and it was causing the soft switch Prism to pop when engaged. I changed their power taps up so that there was one low draw pedal in between all of them and it went away.
|
|
|
Post by digs57 on Jan 19, 2018 10:22:16 GMT -7
Im using a ditto looper alone/single power supply to puts around practing same deal...will try and do this as well...digging new ghia though.
|
|
|
Post by zpilot on Jan 20, 2018 3:49:58 GMT -7
Isolated power supply outputs?
|
|
|
Post by jbrad on Jan 20, 2018 12:56:29 GMT -7
Danelectro recommends cycling the switch rapidly 5 or 6 times on the new Texas Pride anytime the pedal is first plugged in after being unplugged to prevent popping. You might try this.
|
|
|
Post by digs57 on Jan 20, 2018 20:08:41 GMT -7
Isolated power supply outputs? Yes on my small board...have "true tone pro 7"...I had looper (end) after another tc small flashback pedal and both popped...I did read up and try that as well jbrad......
Right to left....RC_AC_STRYMON FLINT_FLASHBACK_DITTO LOOPER at end of chain.
|
|
|
Post by zpilot on Jan 20, 2018 21:14:09 GMT -7
Danelectro recommends cycling the switch rapidly 5 or 6 times on the new Texas Pride anytime the pedal is first plugged in after being unplugged to prevent popping. You might try this. I've had several pedals that required me to do this to eliminate pops when switching. If I recall correctly they were all true bypass and not any particular brand. I just got used to doing it when I first set up for a gig. I think it normalized some built up static charge or something like that. Once it was done I didn't have to worry about it for the rest of the night. The worst was an A/B/C switching pedal from Lehle. That was a very high quality pedal with gold contacts. Like I said, after a few switching cycles the noise totally went away.
|
|