|
Post by bcbeak on Sept 11, 2007 20:01:19 GMT -7
I have had the Maz for a few years and finally decided to change the tubes. Ordered the correct numbers and installed. I have never changed tubes before.
When I turn on the amp ... and take it off standby I get huge distortion and rumble until I turn it back on standby and then on again ... .then the sound goes away and operates normally.
Again I am a complete Tube newbie. What did I do wrong?
|
|
|
Post by rcrecelius on Sept 12, 2007 7:27:01 GMT -7
If you replacing the EL84's...make sure that the "short" end of one of those wire tube retainers didnt get caught under the tube - it can short one out.
Let us know which tubes you were replacing...it might narrow it down a bit.
|
|