|
Post by argytar on Feb 24, 2010 12:02:57 GMT -7
Hi again! I m expecting a new 2x10 JAZ by the end of next week so I was wondering if I could link my 16ohm 212 cab with the JAZ as an extension cab through the 16ohm output jack ,while the 2x10s are playing connected to the 8ohm output jack? is this possible? will the amp lose definition? thanks!
|
|
|
Post by JasonM on Feb 24, 2010 13:51:23 GMT -7
I don't think you can do it like that. In order for me to run an extension cab with my Dr. Zs I have to use a Y-cable. I would post this question over in the 'Cabs and Speakers' area also, someone will most likely chime in.
|
|
|
Post by bluzman on Feb 24, 2010 19:03:08 GMT -7
Don't plug into two speaker holes on the back of the amp.
|
|
|
Post by argytar on Feb 24, 2010 22:22:33 GMT -7
thank you very much !!
|
|
|
Post by tronus on Apr 4, 2010 9:56:49 GMT -7
I know that I can run my 2x10 and my Avatar1x12 at the same time my using the parallel plugs on the avatar. I just gotta make sure to send out from the 4 ohm on my amp because the two loads (8 and 8) create four. Would doing the same thing with my 2x12 8 ohm cab work too, or is that to many speakers to try and power?
|
|
|
Post by tronus on Apr 6, 2010 20:14:09 GMT -7
Got the go ahead over at TGP! Just had to make sure the load is matched with the amp. I knew that, I was just worried about the amount of speakers but realized half stacks are kind of the same concept. I guess it kind of was a stupid question. It doesn't hurt to be sure though!
|
|